Lasted edited by Andrew Munsey, updated on June 15, 2016 at 1:58 am.
You are here: PES Network > Main Page > There was an error working with the wiki: Code[1]
> Directory:Bedini SG:Materials > Australian Sourcing
----
'Sourcing Directory:Bedini SG:Materials in Australia for John Bedini's Directory:Bedini SG'
The following is the list of harder-to-find materials required to replicate the Bedini School Girl motor-energizer as presented in this project. Note this also applies to New Zealand aswell, the RS Components website is http://www.rsnewzealand.com/
listed alphabetically.
Obtained 75mm long spool with 16mm ID core from purchasing spool of solder from local Dick Smith Electronics. Cost of solder spool $12.00. It was difficult to local options on this as most wire spools are much larger with 65mm ID cores.
1st December 05 - Found the correct sized spool at Rays Outdoors - Mentone. Fishing line spool. Surecatch thunder tf7 15lb $8.99 36390
1N4001 1A, 50V Available from RS Components Pty Ltd
Stock number 261148
only available in strip of ten, total cost $1.50
1N4007 Stock number 3485397
Only available in strip of 10, Total cost for 10 = $1.70
Available from RS Components Pty Ltd
ph 1300 656 636
www.rsaustralia.com
awg is converted to swg
20 awg becomes 21 swg only available in 100 m spools, cost $31.80 + GST
Stock number 357772
Avaiable from RS Components Pty Ltd
ph 1300 656 636
www.rsaustralia
23awg becomes 24 swg and is available in 200m spools, stock number 357750
Cost $34.7 + johnny
http://www.imsolutions.cytek.com.au
http://www.magneticsolutions.com.au
http://www.nzmagnets.co.nz/
Neon lamp wired end 4mm, stock number 811608
RS Components Pty Ltd
ph 1300 656 636
www.rsaustralia.com
47 ohms stock number 149638, only available in strip of ten, total cost of ten = $1.50
RS Components Pty Ltd
ph 1300 656 636
if using 10k ohms potentiometer stock number is 160095 cost $4.65 each
2N3055 Transistor, stock number 3489311, cost $ 5.60 each
RS Components Pty Ltd
ph 1300 656 636
www.rsaustralia.com
Australian participant in Bedini SG project:
Sean Moran Victoria, Australia
Directory:Bedini SG:Instrumentation
Directory:Bedini SG:Assembly Instructions
Directory:Bedini SG:Operating Instructions
There was an error working with the wiki: Code[2]
There was an error working with the wiki: Code[3]
There was an error working with the wiki: Code[4]
There was an error working with the wiki: Code[5]
There was an error working with the wiki: Code[6]
There was an error working with the wiki: Code[7]