Directory:Transverter
From PESWiki
| Table of contents |
Transverter? Rotoverter
The TV (transverter) is a solid state single phase system, whilst the RV is a rotary three phase system. Both are based on the same principle of resonance, where the primary is excited with 1/4 of the rated voltage, and the secondary has the RF resonance. In the case of the TV, primary and secondary is self-explanatory (transformer). In the case of the RV, the primary is the lines you connect to the grid, the secondary is the rotor and the amplification is gives back to the 3PH stator. (Both have the same kind of efficiency, however working with a 3PH system is more convenient, as you have a rotary field, whilst in the TV you have a static field. (you could however make a 3PH TV with 3 single phase transformers or with a 3PH transformer)
Required
- transformer (wired 4:1 - example 480:120VAC, you must drive the input with 120VAC! = 1/4V), a Directory:Transverter:Ferroresonant_transformer is usually preferred
- grid input OR variable freq power source - PWM Inverter
- oil capacitors
- electronic switching to extract power from resonance (diode plug or diode bridge)- OS:Rotoverter#ZPE_component_resonant_power_extraction_circuit
Electrical Energy Amplifier
Electrical Energy Amplifier - ARK Research - Hector (http://www.nuenergy.org/alt/energy_amplification.htm)
Electrical Energy Amplifier
1999 Prototypes
January 06, 2002 Prototype
Subject:
Re: Transverter
Date: Mon, 21 Jan 2002 00:48:03 +0000
From: "arkresearch ²" <arkresearch@hotmail.com>
To: nuenergy@cyberportal.ne
Today I took from storage a DEC 10 power suply ferroresonant transformer DEC 16-1491 rev D (part number ) used 1200v 22.5 uF capacitor in the resonant coil (ac primary input 117V 3.8A ) 444.6W 573V 5.5A 3151.5 W circulating power in resonant coil, if diode plug is used as in plan with X 2 capacity each capacitor will become a half resonant Tank circuit becoming in a sense a VECTOR accumulator one negative and one positive "half" in "resonant" mode, if discharged in sequential pulse mode the power is awesome compared to the input. The ratio in this transformer circulating power was over 7:1. All this time we were forced to asume this was a POWER FACTOR phenomena and that this power was not EXTRACTABLE in any way ...well not any more with proper tuning and pulsing circuits or simple "spartan" resonant direct connections it can be used, I hope you can find FR transformers or get a standard one 120/240/480V primary 120/240/480V sec and turn the secondary into a resonant tank, transformer will hum and if tuned right will "drift" with input frequency "TUNE". No shunt needed since no core secondary current "regulation" is going to be used.
After this first step try diode plug use x 2 capacity.
Note: Circuit will not HUM it will do a PUNK! and input current will be a NO LOAD VALUE, but be very careful, x 2 voltages and x 2 currents will be present at Plug + - terminals. Pulse extract power into resistor bank until system goes resonant (Hum) max "Q" if possible.
Try to replicate the FR RC effect and use the diode plug system, this simple device make many obsolete by all terms.
This is simpler and cheaper than the rotoverter 3PH systems ...Transverter systems may be the Volskwagen of OU systems for the money-"handicapped" research guy!, transformers are cheap!, capacitors also, BUT I RECOMMEND GREAT CARE, DEVICE IS EXTREMELY DANGEROUS if safe parameters are obiated. I give them public ...statutory copyright so print and date as original feel free to replicate in vitro. (built prototype) and validate. Any question just ask me! many OPTIONS to extract power are possible.
Anyway,here is the latest 1000w light Bulb rotoverter test, DANGER OK! don't even try to make sense of the output readings its a VIRTUAL mess and a theoretic nightmare (normal rules does not apply on 3PH multi-resonant interactions with semi-rectifying loads, Exploded some mercury 1500w GE bulbs like grenades so be careful with the TUNNING of the system if trying to replicate, 100uF at 370V is FATAL to touch.
-Hector
January 21, 2002 Prototype
Related info
Transverter Secrets Revealed: Data from 1999 series of experiments
480/220VAC transformer design:
The circuit here consists of 2 half LC tanks as known the RADIANT flashover occurs at TURN ON, one capacitor charges to maximal resonant value then the cycle goes in opposed sinewave as the other charges in resonant condition the first one is DISCHARGED in the second transformer with a nominal gain of 1.618 if properly tunned, this second circuit deplete C V value as near to 0V as SCR switches off at a minimal remanent voltage (minimal) before primary tank reverses sinewave to reload half LC and discharge the other loaded capacitor.
The discharge does not affect input tunning as its at opposed non-coupled relation this permits the full vector of the power components to be decopled from the source (totaly non-reflective) as to permit a PERFECT resonant tune of LC as to charge capacitor in RF radiant operation mode.
Now you have the BASIC and simple design of the looped transverter circuit , just be Verry carefull with it ,use at minimal power and follow safety common sense I dont want you to have any incident with this device ,as you validate feel free to post (its quite demanding in its tuning) post this letter with your results as EXTRA information for others to follow.
For basic triggering you can use multy-vibrator optoinsolated mode a simple switching diode set up to trigger the opposed capacitor when charged, input ac regulates the timing, LOAD regulates the discharge time so overal time must be shorter (lower impedance) to increase frequency (shorter pulse) shorter discharge time as to reduce capacitor voltage value to near 0.
Hector D Perez Torres
Transverter Replications
Transverter Circuit & PCB
Hector's OU resonance extraction circuit - nonreflecting extraction
Overall prescription for the right operation (compiled from notes):
- diode plug (OR diode bridge)
- discharge the capacitor at the time the other is charging
- use SCRs for high voltage, bang to the low impedance primary
- extract the power (BEMF) from the secondary (1:5 recommended), capacitor (3:1, as practice) - note that this is for the circuit where capacitors are discharged through the SCR into the transformer in 'DC mode', where BEMF is sent to the output (capacitor + load OR other system). This is another energy cascading based on E.A.S.E.R. theory but requires tuning and design common sense.
- switch the power out from capacitor into load OR Rotoverter primemover
Here is the implementation of the diode plug resonance recovery for the Transverter. A portion of the resonance is directed into the diode plug and switched out through the SCR's. SCR's are triggered by the clever diac + inductive coupling circuitry.
Note that the direction of the inductive coupling is important so when the system will not trigger the SCR, it is usually that you have to change the polarity of the small transformer that does the inductive triggering.
The drawback of this AC system is that the final load must be low resistive to ensure the capacitor discharging before the next cycle comes up. The system can be designed as DC pulse system to improve it.
Hector Transverter April 19 2007
EASY transverter.....
TAKE ANY ferroresonant transformer USE as is ...
POWER up to resonance then start to lower power input until you find the cutoff point, that is the minimal self substaining power it requires... (Study its RADIANT energy (RESONANCE). and OU condition...( Iron core laminate ferroresonance )
NEXT Experiment is tapping the PERPETUAL "TURN ON" RADIANT HALF SINE-WAVES ... (Normal power input)
GET EXTRA capacitor (identical to original one) and USE the diode plug plus the non reflective extraction system ... Capacitor Joule
potential X 2 x 1.618 x Q factor and x 1.732 if 3 PHASE trafo is used.
Radiant energy right off the slelf , split - + and discharged non - reflective to "X" load (whatever)it be .
Links
- Original article (http://www.nuenergy.org/alt/energy_amplification.htm)
- Jini's Transverter replication (http://www.m-primus.com/www/de/data/tv/tv.html)
- EVGRAY (http://tech.groups.yahoo.com/group/EVGRAY/) - has been covering the topic extensively. Numerous forum members have replicated the RV.
- Rotoverter
- Rotoverter Replications
