Directory:Rotoverter:Vortex Technology with RV cogeneration
From PESWiki
Vortex technology with RV cogeneration
Statutory Public copyright (Other Rights Apply) local and international. (Publication) Scientific discovery, Roto conversion Effect and suck-a-matron covered by the publication statutory copyrights for 75 years.
Introduction to thermodynamic heat transformation to OU regions.
To define OU = COP>1 device.
A heat pumps process is an OU energy transformation in where normally there is a COP>1 where a small electricity input transforms and creates a higher heat energy output for our use. Solar cells and wind generators are COP=infinite systems, which produce electricity where we don't have to use electricity input. However, when looking it from the bigger box - we have the Sun where the energy comes from then the COP<=1.
About thermodynamic conversion systems where energy is transformed from
the ambient heat we can call them OU devices when we get out the useful work, heat, electricity out of it that exceeds the input.
What is important is to learn to transform the energy from the available.
Is it possible to take into (=suck) ambient air, put it to make work and send out cold air and power a motor or generator, can you say what normal science has to say? Is it possible to reverse the entropy?
This is a very important thing here. It opens a door to a higher efficiency understanding
All engineers are trained to push something, to create an energy state that is higher than environment, if they want to do/move/create something. And this procedure is programmed into their engineering curriculum. As the created energy state is higher than environment one, it is logical that a part of the input energy is used for the according task, and the rest flows into environment = losses.
Therefore you can’t reach OU that way. The concept is simple if you create an energy sink, for example as in the low pressure region in the RV-suck-a-matron, the air flows because of its own energy. Not, because the air is pushed or something, but due its own thermal energy. The air molecules are jumping into the "holes�? that are created due to the Sucking.
To visualize this picture one only needs to look at what happens in a VORTEX!
Or one can also consider as does the inventor that the Air cools down due to
Expansion where it does work (not the other way around - makes work and cools down). The additional energy comes from the vortex and the vortex is powered by the gravity that adds up to the kinetic energy of the air flow.
Or by the understanding of, Let this movement do some work, and the molecules will cool down as already explained in the standard physics books describing this simple thermodynamic law. In the case of "pushing", you end up with some done work + some losses. That’s all. In the case of "vortex sucking", you end up with some done work + some losses as well +the NEXT ENERGY SINK (cold air).So, the more energy you are able to extract at sucking, the stronger is the next energy sink, which you will get.
Sucking an air acquires energy, blowing increases waste as you generate heat. So in a transformation method using the thermodynamic principle the rule is to suck and never blow in as in the Suckamatron system or in a turbine, chamber extraction system.
This is where E in BTU goes to a turbine as (electric) (transformed) E=e(-n) (entropy variable) were the air goes BTU - (minus) and the density goes UP were work is performed as per the standard thermodynamic law process.
The extraction system process is the vacuum pressure relative to the density of gas being extracted with a BTU negative subtracted to the vapor pressure density of gas extracted.
A laymen’s description is that it requires less energy to extract the air than the energy that is imparted from the turbine. System is an over-unity transformation engine as a tornado or hurricane...(in a can) is.
Introduction to the suck-a-matron device (implosion tech)
Based on principle of power out is equal to power in or less (minus entropy)
OU: is the Power out summed (transformed) into the acquired power in the system to equal or surpasses the power input of the system.
In the suck-a-matron process
Power creates a vacuum (vortex). The exterior air at an X density then performs work as it tries to fill the void. It then adds more density and drops down gravity assisted (centrifugal force) gaining MORE energy. As it does it is extracted requiring only a small percent of the original energy. This is because the conditions of a higher density and pressure (liquid air) in an EXTREME Thermal reactor configuration. Where energy is used near 100% and the energy sink is totally isolated.
The thermodynamic LAW is as follows: Transformation where Energy out exceeds the energy in. The energy input is transformed and acquires energy from the density reduction via the depleted air sinking to the bottom of the unit extracted by the RV type vacuum pump. This is using much less energy than the one created in the input turbine generator to transform it. The raw basics were tested and gave competent results. Using a vortex method it creates anti gravity thrust (implosion).
The RV technology can be integrated as part of a co-generation construct, proper funding and resources is still needed to perfect concept.
Operating principle introduction
http://www.deutsches-museum.de/ausstell/dauer/physik/e_luft.htm
Hot air being sucked in performs the first work in thermally insulated turbine stages where as the above thermodynamic law describes. It then cools down further as it performs more work gaining more density where the gravity imparts this energy as it flows down through a SINK, pipe or structure designed for such action.
The energy being denser is resulting in the creation of more vacuum force until such air becomes a liquid state as it reaches the lower level in such a pipe or structure. In a pure turbine design the AIR gets denser and by means of a centrifugal cryo pump is removed requiring a fraction of the energy produced by the turbines being self sustaining using PURE heat as FUEL.
The same interpretation comes from considering Hurricanes and Tornados functions. Where we create an artificial condition where the Carl von Linde principle works performing WORK and creating a self sustaining sink, the main factor is the isolation of the COLD sink once the process is created.
Operating principle
You suck air, it enters in at a 14.7 PSI 11psi average and does work at 98% efficiency as in an air turbine. Then self cools like in hurricane and is extracted at 1/273 more density per degree as it cools down performing more work, using the gravity in long chimney structure and the unit self runs.
This is based on the concept of the excess energy comes from the ATMOSPHERIC PRESSURE as we all walking around on the earth under 1 bar pressure. Consider a
Thermally isolated vertical pipe (like chimney stack ) containing foam insulated inside out assisted with an air turbine on top and operating with a suction from the bottom using the RV.
As air performs WORK it becomes dense to LIQUID and goes down to the machine creating a vacuum. A created temperature difference mapped to the applied energy for
separation yields a gravity assisted bottom sucking (extraction).The pressure which earth atmosphere uses to fill the middle of the tube (cold region).
ALL the tube after it exits the turbine being an INSULATED HEAVY DENSITY
GOES Down the pipe sucked from the bottom by the effect from the RV vacuuming pump. Because of the lower molecular air density is "for free". It is OU. It’s a simple 2085 heat transformation engine constructed with the ideas.
Design details that need to be addressed is the WATER must be fractioned in the way down before freezing, to avoid clogging the machine (Icing). The gases can be also fractioned making the machine a liquid gas manufacturing complex ,Oxygen for hospitals CO² for fire suppressing devices and food industry & others and rare gases for industry.
There may need to be additional empirical experiments to solve details and design problems.
Schauberger turbine co-generation
For co-generation the RV is also MOTOR generator initiator for this device and it
generates anti gravity (lift) in an effect described as centrifugal vector redirection were rotary force transfers to a linear one by transition relative movement null. This has been verified from experimenting with sono-fusion turbines creating sonic rotary cavities for water resonance.
For Viktor Schauberger type turbine designs-
[http://www.frank.germano.com/index.htm]
Open sourced engineers really need resources to do TURBINE R&D with the RV prime mover, seal optimization, drag reducing impeller redesign for Tesla or vortex cavitations modes.
VIKTOR SCHAUBERGER and the implosion turbine design is also possible in a cogeneration role having the RV Start such a turbine and then switch to a generator mode in a cheap cost effective way.
please note: this drawing is merely the drawing of an idea,to illustrate the properties of the suckamatron, an idea by someone else, which is working in reverse mode as Hector always suggests.
