PESWiki.com -- Pure Energy Systems Wiki -- your publicly editable site about new energy technologies. Power to the people!
Directory:Resonance power extraction
From PESWiki
There are already numerous power extraction from resonance circuits for the OS:Rotoverter-setup.
- Directory:Rotoverter:Replications:NeonPeak for instance.
The RotoVerter. Designed by Hector D Peres Torres of Puerto Rico, this system has been reproduced by several independent researchers and has been shown to produce at least 10 times more output power than the input power. (http://www.panaceauniversity.org/Chapter2.pdf)
[edit]
Power Extraction from Resonance
[edit]
Phil's OU circuit - resonance clipping
Procedure:
- resonate LC, direct it into full wave rectifying bridge (FWRB) into DC
- clip the power from resonance that exceeds specified voltage level into the capacitor (does not affect the resonance when doing wisely)
- after clipping - discharge the capacitor into the other capacitor -> then into the load (as per original procedure)
- easy to apply to RV alternator as well -> this could be an easier way to get OU at single phase resonance
Here is our implementation how to extract power from the resonance up to 50V level.
Schematic (200602):
PCB (200602):
[edit]
Hector's OU resonance extraction circuit - nonreflecting extraction
- diode plug OR diode bridge
- discharge the capacitor at the time the other is charging
- use SCRs for high voltage, bang to the low impedance primary
- extract the power (BEMF) from the secondary (1:5 recommended), capacitor (3:1, as practice)
- switch the power out from capacitor into load OR RV primemover
