PesWiki.com

Menu

Directory:Bedini SG:Replications:PES:Sterling Allan:Data:Exp4

Lasted edited by Andrew Munsey, updated on June 14, 2016 at 9:14 pm.

  • 8 errors has been found on this page. Administrator will correct this soon.
  • This page has been imported from the old peswiki website. This message will be removed once updated.

Shortcut URL for this page: http://tinyurl.com/3qu4j

You are here: PES Network > Main Page > There was an error working with the wiki: Code[1] > Directory:Bedini SG:Replications > Directory:Bedini SG:Replications:PES > Directory:Bedini SG:Replications:PES:Sterling Allan > Directory:Bedini SG:Replications:PES:Sterling Allan:Data > Exp. 4 Series

----

Image:SDA repl Bedini SG b 90.jpg

'DATA from Sterling D. Allan's fourth series of experiments on His Replication of John Bedini's "Directory:Bedini SG"'

See also, Directory:Bedini SG:Replications:PES:Sterling Allan:Data

Exp. 4.1 in series

Batt. 3,4 and Batt. 1,2 in series, taking turns on the input/output sides. Trickle charger with input side. Transistor going out.

Exp. 4.2 deceleration data

Charted deceleration from 147 rpm to zero.

Exp. 4.3 in series

Replaced circuit with all new components per specs here. Batt. 3,4 and Batt. 1,2 in series, taking turns on the input/output sides. No trickle charger. Watching average voltages (input+output/2). In each set, the average voltage would decrease, level out, then increase above its starting point, but the starting point on the new set compared to the startion point on the previous set ("set" meaning switcing input and output batteries) would be quite a bit lower, so that the net average was gradually decreasing over time.

Exp. 4.4 Supercharging #3,#4

Battery 3 and 4 in series on charging end, with Battery 1,2 in series on input side, with trickle charger on input batteries.

Circuit was in rotation mode, spinning at 153 rpm. Input current: 0.32 amps. Output current: 0.09 amps. Input batteries had trickle charger (12V NAPA 2amp) keeping them topped.

Battery 3,4 started at 12.55v and peaked at 14.72 v. Battery 3 started at 6.17v and peaked at 6.65v. Battery 4 started at 6.37 and peaked at 8.06.

Exp. 4.5 charging in parallel

Experiment ran only a few minutes before stopping because of fried transistor.

Battery 2 was on input side. Batteries 1,3,4 were connected in parallel on charging side. Output current was 0.18 amps.

{| border=1

| Time || B1 volts || B3 volts || B4 volts || B2 volts

|-

| Before || 6.15 || 6.49 || 6.86 || 6.19

|-

| 3 minutes || 6.37 || 6.39 || 6.41 || 6.16

|-

| 14 minutes || 6.37 || 6.39 || 6.41 || 6.15

|-

| Batt #4 alone on output for 4 minutes

|-

| 18 minutes || -- || -- || 6.55 || ?

|-

|}

See also

Directory:Bedini SG:Replications:PES:Sterling Allan - main index includes chronology of build, other replications by SDA when built.

Directory:Bedini SG:Replications

Directory:Bedini SG - main index

Directory:Bedini SG:Data

Bedini SG egroup

- Directory

- Main Page

There was an error working with the wiki: Code[2]

There was an error working with the wiki: Code[3]

There was an error working with the wiki: Code[4]

There was an error working with the wiki: Code[5]

There was an error working with the wiki: Code[6]

There was an error working with the wiki: Code[7]

There was an error working with the wiki: Code[8]

Comments